You may try some ways to weaken the adhesive, such as a little isopropyl alcohol and/or heat (~20-30 C). Turn the lens around so that it is "looking" upwards and place it on a table. Do not proceed unless you are sure that you are willing to void your warranty. Make sure the sensor does not touch the surface.īefore completing the next step, read through all of the steps and decide whether you are willing to void your warranty. Lift up the board and place it down on a very clean surface. There is a gasket of slightly sticky material between the housing and PCB which will require some force to separate. Be careful not to let the washers roll away. Unscrew the two 1.5 mm hex lock keys on the underside of the main circuit board. Work in a clean and dust-free environment, as the sensor will be exposed to the air. Camera Serial Interface 2 (CSI2) "Unicam".Driver differences when using libcamera or the legacy stack.Camera Tuning and supporting 3rd Party Sensors.Understanding and Writing your own Apps.Writing your own Post-Processing Stages.libcamera and the legacy Raspicam camera stack.
0 kommentar(er)
